VelAir Pebble Mini Bedienungsanleitung Seite 2

TECHNICAL SPECIFICATIONS
User Manual
Item Category
Operating Voltage
Rated Power (heat on)
Rated Power (heat off)
Standby Power
Air Speed
Motor Type
Sensor Type
Sensor Range
Timing Protection
Drying Time
IP Rating
Isolation
Unit Size
IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
!
PERSONS OBSERVE THE FOLLOWING:
• Use this unit only in the manner intended by the manufacturer. The manufacturer is not
responsible for any damages caused by misuse or defective installation.
• The instructions contained within the installation template must be followed carefully
when installing this unit. Failure to accurately follow the instructions may result in the
incorrect operation of this unit, damage to property and/or personal injury.
• Installation work and electrical wiring must be done by qualified person(s) in accordance
with all applicable codes and standards, including fire-rated construction.
• When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
• This unit must be powered by a dedicated circuit branch protected by a circuit breaker
with the appropriate rating. The correct circuit cable must be used to meet the current
consumption for this unit.
• This unit has been designed for indoor use only. Protect from water, sun and extreme
temperatures. Do not install outdoors or close to moisture and/or heat generators.
• This unit cannot be modified. Qualified person(s) must be used for maintenance, any
repair work or unit removal. If the units stops or works incorrectly, contact your regional
dealer or contractor.
• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved. Do not allow children to play with the
appliance or carry out cleaning and/or user maintenance on this hand dryer.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Performance Data
AC 220~240V, 50 Hz- 60 Hz, 800W
800W
400W
≤ 0.7W
96 m/s
Brushed Motor, 30,000 RPM
Auto Infrared touch free operation
45° 15~25cm
50 seconds auto shut off
10 ~ 12 sec
IPX3
CLASS II
H 229.9mm x W 263.4mm x D 133.4mm
UNPACKING
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the hand dryer from the shipping carton, using care not to drop the appliance.
3. Inspect carefully for any damage that may have occurred during transit. Check for any loose,
missing or damaged parts. If the hand dryer is damaged, promptly inform the shipper or dealer
where you purchased it.
Standard items with the hand dryer are shown in Fig.1 together with tools needed by the installer.
1
Installation
Unit
template
(Terra4 Docking
Station attached)
INSTALLATION
1. Terra4 Docking Station® removal
1.1 Place the appliance on a cloth to avoid marking its surface.
1.2 Remove the one security screw seated on the bottom surface of the unit,
using the service tool (fig.2).
1.3 Pull down the Terra4 Docking Station® and remove from the unit (fig.3).
2
CAUTION
• Make sure power supply breaker is switched off.
• Check that the electrical supply corresponds to that shown on the rating plate. If the unit is
connected to any electrical supply other than stated on the rating plate of the unit, permanent
damage or unsafe operation of the unit may result.
• The unit must be mounted on a flat vertical wall capable of supporting the full weight
of the unit.
Service Tool Power cable cover
Wall mounting
& Spare Screw & Screw
anchors with screws
3
1
EN
2