Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Led Floodlight Installation and Instruction Sheet
Note: Please read the following instruction before installation and keep it for future reference.
1. Main Structure and Scope of Application
The housing of the lamp is made of a pressure-cast aluminum al. The surface has been treated with
an electrostartic coating and is characterized by strong adhesion, water resistance, dust resistance
and a rational construction.
The lamp is mainly used in indoor and outdoor
This lamp is equipped with motion sensor. It will activate by the human motion around the lamp.
The lamp will shut off automatically after the delay time is reached.
2. Main construction data as following:
LED-10W-M
Power: 10W / 230V / 50 Hz / 0.05A
Beam Angle: 120°
Color temperature: 6000K
Lumens: 700-1100 Lm
Protect level: IP44
Projection area: 4-20m
Induction distance: Max.10m (25°C)
Induction angle: 120°
Delay time: 10 seconds - 7 minute
3. Installation instruction
a.Ensure that the mains voltage is switched off before mounting
b.Align the motion sensor to direct the lighting area, make sure nothing will block between the sensor and the
lighting surface.
c.Use approved supply cable H05RNF3X1.00MM, making sure that the grommet is used to ensure
that the housing remains waterproof. Connect the yellow/green conductor of the connection supply cable.
d.When the lamp protect glass is broken, please change it as soon as possible, Never use the lamp without
protect glass.
e.Driver is included.
4. Maintenance and cleaning
a.Disconnect the product from the power supply before you clean it.
b.Clean the product regularly with a dry, fluff-free cloth. Use a slightly moist cloth to remove any stubborn dirt.
c.Do not use corrosive cleaning agents.
d.Never immerse the product in water or other liquids, Do not use strong water jet directly onto the device.
Dispose of electrical appliances in household garbage.
In accordance with European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation
into national law, electrical equipment collected separately and environmentally friendly recycling are fed.
2
, decoration, tunnel, avenue, garden, etc, for illumination.
LED-30W-M
Power: 30W / 230V / 50 Hz / 0.15A
Beam Angle: 120°
Color temperature: 6000K
Lumens: 2100-3300 Lm
Protect level: IP44
Projection area: 15-30m
Induction distance: Max.10m (25°C)
Induction angle: 180°
Delay time: 5 seconds - 8 minute
2
Werbung
