V7 SNMP Web Pro Schnellinstallationsanleitung Seite 2

1. Overview
1. Ethernet port (10/100/1000Base-T)
2. Sensor port/data transmission port
3. Edge connector: connects to UPS slot
4. Ethernet port status LEDs
5. Jumper to restore default setting
6. Running speed LED for Ethernet 1000Mbit/s
Ethernet Port Status LEDs:
Link status LED (Green)
1000M LED (Yellow)
Pin Assignment for Jumper
Pin #
Pin 1 + Pin 2
Pin 2 + Pin 3
Note: After the card is restored to default, make sure to change the jumper setting back
to Pin 1 and Pin 2 for normal operation.
Flash Link Active
Off Card is not connected to the network
Flash Port is operating at 1000Mbit/s
Light Port is operating at 100Mbit/s
Off Current web bandwidth is 10Mbit/s
Status Description
Closed Normal operation
The IP address of the SNMP web card and
password will restore to default setting.
Closed
Default static IP address: (192.168.102.230)
Default password: 12345678