Herunterladen Inhalt Inhalt Diese Seite drucken

Use And Maintenance - Create AIR PURE COMPACT Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 41
After plugging it in, press this key to turn it on / off and the automatic operation mode
and ambient temperature display will be the default.
When the product is running, press this key to adjust the running wind speed and adjust
it in low, medium and high speed cycles. The LED screen displays the wind speed icon
at the same time, indicating the current operating wind speed status.
Press the timing key for the first time to select 1h, 2h, - 8h timing mode or 0h to cancel
timing. When a certain timing state is selected, the timing icon of the display screen flas-
hes three times slowly and then it is always on, which means the timing is effective. The
second press will be timed to view, the third press will reschedule the operation.
Press the automatic key to enter the automatic operation mode, and the system auto-
matically adjusts the wind speed according to the detected ambient air quality to
effectively purify the polluted air. (Repeat in Low Speed Mode)
Press the sleep key to enter the mute and rest screen operation mode, and press the
power button once to resume the normal operation mode.
Press the power button for a long time and you will hear a beep to turn on or off the
Bluetooth function.
After the Bluetooth pairing connection with the mobile phone ( Bluetooth name SM -
222B ) is successful, the mobile phone music can be played and the sound volume can
be adjusted. Press the wind speed button for a long time to search Bluetooth function
again.
UV
UV sterilization icon display.
Running wind speed icon display.
PM 2.5 Icon Display: (0-15) Good-Blue; (16-35) Medium-Purple; (36-75) Unqualified-Red;
PM2.5
(76-999) more than moderately polluted - Red flashing.
1. Unplug the air purifier and place it on a table. Pull the front panel from the side notches
and carefully remove it. You have to release the three grip tabs that are located under
the front panel.
Note: The USB corner must be opened first, and the operation must not be done with too
much force, otherwise it will damage the internal connection.
2. Then rotate the product 90 degrees to leave the front panel facing up, now the front
panel is open and you can see the FFC lineup attached to the panel.
U SE A N D M A I N T E N AN C E
E NGLI SH
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis