OP UNISPEED US-FL/01 Betriebs- Und Wartungsanweisung Seite 37

OP
S.r.l.
25131 BRESCIA - Via del Serpente, 97 - Tel.030/3580401 - Fax 030/3580838
                                                                                                                                                               
FOR PREFITTING WASHERS ON DIN 2353 UNIONS:
•
•
•
• PLACE THE BUSH ON THE ROD KEEPING IT CLEAN AND LIGHTLY GREASED
(RECOMMENDED TYPE OF GREASE KLUBER STABURAGS NBV30).
•
FOR FLARING PIPE TO 37° FOR SAE-JIC UNIONS:
•
• RAISE THE SAFETY HATCH (FIG.4 POS.1)AND INSERT THE FLARING PUNCH ON THE
PISTON ROD.(FIG.4
(RECOMMENDED TYPE OF GREASE KLUBER STABURAGS NBV30)
•
•
WORKING PHASE
•
•
•
Make sure the pipe to be machined has been thoroughly deburred inside and out
PREFITTING WASHERS ON DIN 2353 UNIONS:
•
•
•
POS.2) KEEPING
37
IT CLEAN AND
•
•
•
LIGHTLY GREASED