Tiiwee 03 Bedienungsanleitung Seite 3

The instructions for pairing the Door & Window sensor with the Tiiwee Home
Alarm System are included with the Tiiwee Alarm Kit manuals. The manual is
included with each kit. It can also be downloaded from our
website www.tiiwee.com. Also detailled instructions can be found one of our
Youtube channels.
Installation: General Installation Guidelines
• Do not install the sensor near magnets or magnetic devices - this may cause
the alarm to be activated accidentally.
• Clean all surfaces carefully before installation.
• The principle of the system is that an alarm is triggered when the sensor and
magnet are separated because the window or door is opened.
• If possible, mount the sensor on the door frame and not on the door or
window itself. This position reduces the wear and tear that occurs when
windows and doors are closed (shocks. This increases the service life of your
sensors.
Installation of the Door & Window Sensor
IMPORTANT - PLEASE NOTE:
• It is essential that the sensor and magnet are aligned correctly and are at the
same level using the triangle marks.
• The distance between the sensor and the magnet should not exceed 5mm.
How to mount a door sensor (please see the inside of the front page)
Image 1: Door and doorpost are at the same level. Position the sensor and
magnet next to each other. Now, position the magnet and sensor so that the
triangle markers are close to one another.
Image 2: The door is protruding relative to the doorpost. Mount the magnet
sideways on the top of the door. Now, position the sensor on the doorpost at a
Copyright © 2020 Tiiwee. All rights reserved. This manual or any portion thereof may not be reproduced or used in any manner whatsoever.