EuroLite FWS-300 Bedienungsanleitung Seite 8

Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
If the device will not be used for a longer period of time, remove the battery in order to avoid battery leakage.
In order to have a long battery life, you should only use alcaline batteries.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.
Operation
Turn on the device via the ON/OFF switch.
The LED lights up in green.
The sensitivity can be adjusted via the sensitivity switch:
High sensitivity = for small metal objects such as coins,etc.
Low sensitivity = for large metal objects such as handguns, knives, etc.
You can measures low sensitivity by pressing the sensitivity switch and holding it down during use
Pass the metal detector over the surface to be examined.
The device emits a loud tone and the LED lights up in red, as soon as metal is located.
The device can also be switched to silent mode by pressing the vibrator button and holding it down during
use. The metal detector begins to vibrate and the LED lights up in red, as soon as metal is located.
Warning: Danger of explosion when recharging standard batteries!
Please use either rechargeable batteries with the battery recharger or standard batteries only.
Danger of explosion when battery is replaced improperly.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Caution!
8/9
1. Detection face
2. LED (red or green)
3. Audio alert
4. Sensitivity adjuster
5. Handle
6. Battery lid
7. Sensitivity switch
8. On/Off switch
9. DC IN-socket for
rechargeable batteries
10. Vibrator button
00023892, Version 1.3