Seite 4
5x klein 2x groß 5x small 2x large Räder zuerst durch die Löcher an der Seite wo Teil 27 nicht geklebt ist führen. Dann Rückwerts in das gegenüberlegende Loch stecken. Push the wheel axels through the holes on the side where part 27 has not been glued. Then reverse and push them into the opposite hole.
Seite 5
Noch nicht auf der Bodenplatte kleben Do not glue to the base yet. Noch nicht auf der Bodenplatte kleben Do not glue to the base yet. Jetzt [16] und [17] von innen auf der Bodenplatte kleben. Glue [16] and [17] from the inside to the base.
Seite 7
Zuerst die Spindel oben kleben. Eventuell kürzen Sie die Spindel damit die Brücke höher liegt. Zuerst die Drähte Attach the worms first. If you want the befestigen ! bridge positioned higher you can shorten Attach wires first. the worms. Stahldraht Steel wire Bevor Sie die Wellblechbude auf der Bodenplatte kleben...