Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CUSTOMIZATION OF THE ACCESS CODE
OPERATIONS TO BE MADE ON THE KEYPAD
Key in "ENTER" + PROGRAMMING CODE (factory code is
1
999999) + ENTER
2
Key in within a minute the KEY 2 + ENTER
3
Key in the NUMBER OF THE CHOSEN CHANNEL + ENTER 1 BEEP of 1 second
4
Key in the NEW ACCESS CODE + ENTER
5
Repeat the NEW ACCESS CODE + ENTER
The same operation has to be made for each channel to be programmed.
DISABLING A CHANNEL
To disable a channel repeat the points 1,2,3 above and proceed a s follows:
OPERATIONS TO BE MADE ON THE KEYPAD KEYPAD SIGNALLING
4
Key in "0" + ENTER
5
Key in again "0" + ENTER
KEYPAD SIGNALLING
1 BEEP of 1,5 seconds + LED1 and
LED2 on for 1,5 seconds
1 BEEP + LED2 on
1 BEEP of 1 second
• 1 BEEP of 3 seconds if the
operation is correct;
• short flashes of the LED if incorrect
1 BEEP of 1 second
• 1 BEEP of 3 sec. if the operation is correct
• short flashes of the LED if incorrect
- 23 -
ENGLISH
Werbung
