Werbung
0
2cLock
2up
SNOOZE
SETTING THE CLOCK — wy
Reuicunaba
1 Connect the AC power cord to a wall outlet (@).
The clock display begins flashing.
2 While holding down CLOCK, press UP or DOWN to set
the clock.
Using the UP button changes the time faster.
The clock starts running at "00" seconds.
To display the seconds, press SNOOZE.
The seconds are displayed while the button is pressed.
~ ©
® The 1st digit of the minute
© Seconds
About the clock display
You can change the brightness of the clock display.
Set the DIMMER switch to select the brightness of the display.
To turn off the clock display, set the DIMMER switch to
DISPLAY OFF.
However, it may not go out when using in a
bright place.
;
Even if the DIMMER switch is set to DISPLAY OFF, you.can
see the clock display for about 5 — 10 seconds by placing your
hand on the sensor @ of the unit.
Werbung
