EXTRALINK LCV-06 Turbo&Overturn Bedienungsanleitung Seite 4

INSTALLATION
4.
Assembly (portable for use of floor)
Fit the feet before using the appliance (supplied unfitted in box). The feet must be fitted on the underside of
the appliance with the 2 self-tapping screws. Make sure they are correctly positioned at each end.
OPERATION
5.
Read the User Instructions carefully before use.
Save these instructions for future reference.
NOTE: The appliance may emit a slight smell or fumes the first time it is switch on, or if it has not been
used for some time. This is normal.
Set the required temperature.
1. Put the appliance in a suitable place, with due consideration to the above safety instructions.
2. Plug the power cord into a suitable mains outlet.
3. Turn the thermostat control to max.
4. Switch on the fan. Lamp 2 goes on when the appliance is switched on. For maximum heating, turn the
selector to position 3.
5. When the required room temperature has been reached, slowly turn the thermostat anticlockwise until you
hear a click and the lamps go off. The appliance will then switch on and off automatically to maintain a
constant room temperature.
6. If you do not want to heat up the room as quickly, turn the output selector to I or II. Start the fan to increase
the circulation of heat. The fan only works if the output selector is in position I-III.
The heater has a thermal cut-out that trips if the appliance overheats. If the cut-out trips, disconnect the
heater from the wall socket and allow to cool for 5 minutes. Investigate the cause of the overheating before
connecting the heater to the wall socket again.
4