Batteries Replacement - Meta System T.36 Pulsar Benutzerhandbuch

When replacing the batteries, follow the procedure shown below. Warning! If you want to reset the "Connection time"
to modify the programmable awakenings and the autonomous positions, it is necessary to remove the batteries for
more than 3 minutes (see Meta Trak Pulsar App User Manual).
Place the cover removal tool on a smooth
surface and place the device on it.
Use only PANASONIC CR123A batteries supplied with the product and available at any authorised Meta System retailers.
WARNING! Risk of fi re and burns. Do not recharge, disassemble, heat above 100°C or incinerate.
Do not mix fresh batteries with used lithium batteries or other battery types.
ATTENTION: THE TWO CR123A BATTERIES MUST HAVE THE SAME IDENTICAL CHARGE VALUE.
ATTENTION: IT'S RECCOMENDED TO REMOVE ANY ADHESIVE RESIDUES

10. BATTERIES REPLACEMENT

10
FROM THE BOTTOM OF THE DEVICE TO ENSURE ITS OPENING.
24
*
Press down at both ends
to release all clips simultaneously.
11