QisDESIGN CR01 FR Bedienungsanleitung Seite 4

Installation
Note: The installation should be performed by an adult person.
(1) Open the packaging. Remove the first cardboard plate that covers the floor light base
from the box and place it on the floor near one side of the box. The cardboard plate can
be used as a protective measure against scratching and impact for later installation.
(2) Remove the second cardboard plate that contains the floor light base from the box and
place it on the floor near the other side of the box. Pay attention to the wiring and
prevent it from being stepped on or cut.
(3) Remove the three protective cushions from the box and place them on the floor evenly in
between the two cardboard plates.
(4) Assemble the lamp. Carefully take the floor light out of the box and place it on the cardboard
plate and protective cushions. To assemble the floor light pole, twist the two pole sections in
opposite directions until they interlock firmly. To assemble the floor light base, insert the floor
light pole into the center hole on the floor light base and secure them with the 17mm hex nut
(can be found on the wiring) and a 17mm open-ended spanner. Secure the cable on the
base with the cable clip and a crosshead (+) screwdriver.
(5) Connect power. Check the installation and then lift the floor light upright. Connect one side of
the power cord to the power adapter
Using the Lamp
Maintenance and Troubleshooting
Cleaning the Lamp
Turn off the lamp first, and unplug the lamp from the power outlet. Use a soft and dry cloth to
wipe any smears or dusts off the lamp's outer casing. Do not use any chemical solvents like
kerosene, naphtha and so on, as the lamp's casing may become damaged.
Cleaning the Wiring
• Use only a dry and soft cloth to wipe the lamp's wiring clean. Never use a wet cloth, as it
may cause an electric shock.
• Do not rinse the lamp or any of its components directly with water.
Troubleshooting
If you encounter problems when using the lamp, check the following:
• Are there loose connections between the power cord and the power adapter or the
mains power outlet?
• Is the power switch turned on?
If the problem persists, please contact your nearest authorized service center for help.
Specifications
• Model: CR01 _FR
• Power input: 100-240V AC/50-60 Hz
• Power consumption: 20W
• Operating temperature: 0 C - 40 C
• Size (the lamp only): 483 x 329 x 1680 mm (W x D x H)
2 English
, and the other end to a wall power outlet
1
When the lamp is off, gently step on the foot switch to turn on
the lamp.
Note: Only gently step on the foot switch to turn on or off the
lamp. Do not apply too much force on the foot switch or
place heavy objects on it.
When the lamp is on, gently step on the foot switch to turn off
the lamp.
.
2
www.QisDesign.com