Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembling instructions
Assembling by adults only
Please check, before assembling, that there are no missing parts.
In case of missing pieces, contact the address mentioned under "Guarantee".
Equipment:
4 Feet (D)
1 Bottom piece (E)
1 Cover with stove top and sink (F)
2 Side parts (G)
1 Back wall (H)
4 Strips to fasten side- and back pieces (I)
1 Intermediate strip, horizontal (J)
1 Element with rotary switches (K)
1 Oven door (L)
1 Door (M)
1 Sink (N)
1 Panel board (O)
1 Intermediate strip, vertical (P)
A
B
C
1.
Begin by screwing the two back feet (D) to the bottom piece (E). Simultaneously fasten the two back strips (I) to the bottom piece. Use two screws C. (Drawing 1-3)
2.
Use a screw C to fasten the foot (D) front left to the bottom piece (E). Simultaneously fasten the strip front left (I) to the bottom piece. (Drawing5+6)
3.
Insert the vertical intermediate strip (P) into the predrilled holes of the bottom piece (E). Then fasten the vertical intermediate strip with a screw A. (Drawing 7)
4.
Now insert the oven door (L) on the left. (Drawing 8)
5.
Insert the other door (M) on the right. (Drawing 9)
6.
Use a screw B to fasten the intermediate strip (J) onto the strip front left (I). Make sure, the door (M), the oven door (L), and the vertical intermediate strip (P) are attached to
the horizontal intermediate strip (J). (Drawing 10)
7.
Insert the element with the rotary switches (K) into the strip (I) front left. (Drawing 11)
8.
Now use a screw C to fasten the foot (D) front right to the bottom piece (E). Simultaneously fasten the strip (I) front right to the bottom piece. Make sure, the door (M), and the
intermediate strip (J) are attached to the side strip. Use a screw B to fasten the intermediate strip (J) to the strip front right. (Drawing 12+13)
9.
Push the two side pieces (G) left and right between the front and the back strips. Push the back piece (H) between the two back strips. (Drawing 14 -16)
10. Use two screws D to fasten the panel board (O) onto the cover (F). Insert the sink (N) into the cover (F). Drawing 17)
11. Now put the cover (F) on. Attach the cover to the four strips (I), using four screws A. (Drawing 18)
A
C
Fastening material:
A
D
A
C
4 Pieces
2 Pieces
4 Pieces
2 Pieces
1 Pieces
A
B
C
Werbung
