KOOMANDO RX-MULTI Bedienungsanleitung Seite 2

EN
RX-MULTI 300
Instruction
1. RX-Multi drawing
2. Brand selector
With 8 bits dip witches, the user can make different combinations
shown below in table 1.
3. Learn Button and LED
In RX-MULTI receiver, there are 2 independent channels. Each channel has independent
L2 corresponding led.
4. Power Input Selector
The RX-MULTI can work at input AC/DC 12V—30V. However, it's better to change the jumper according to the power
input. If the input is over 24V, shorten pin 2&3; shorten 1&2 if input is under 24V.
5. Exchangeable Memory
The memory card can be removed from board to inseri in a different receiver.
6. How to entry remote and Erase all remote
1. First, select the correct brand for remote that will be entry (by dip switch).
2. Press the learn button,
flashes 4 times, this remote button entry into the RX-MULTI successfully.
3. Repeat step 2 for another button.
4. Both channels
7. Faac remote controls
Only Master remote controls can be memorized, to check if the remote control is Master keep any key pressed, the
LED must flash briefly and then turn on steadily.
Store a Faac series SLH
put the Dip-Switches as indicated (pos. 4 for 433 Mhz, pos. 20 for 868 Mhz); set the remote control by pressing but-
tons 1 and 2 together and releasing as soon as the LED starts to flash; press on the receiver the key of the desired
channel (Sl or S2), the relative LED turns on; press the key to be memorized on the Faac remote control, the led
on the receiver stops, press the key to be memorized on the Faac remote control again, the receiver LED flashes to
indicate that it has been memorized. The operation must be performed quickly to prevent the receiver from leaving
the learning phase. Remember that each remote control must be memorized in this way, the copy procedure between
Master remote controls is not enabled on compatible receivers.
8. Erase all data in memory
Pressing and holding either learn button, the LED starts flashing. Keep pressing this button until the LED tums off. All
data in the memory card will be erased permanently.
Notice: Be carefully at erasing all data in the memory card. The data will be erased permanently
vered.
WARNING!
It is important to follow the manual for your safety.. Multiservizi
the product that causes damage to property and / or people.
DANGER
Make sure the device is not live before doing any work.
THE INFORMATION
Distributed by MULTISERVIZI - via Giovanni Paolo II, 45/C - Azzano Melia (BS) - ITALY - 030 974 54 00 - info@itelecomandi.com
A 868 MHz
20
-o
00000000
Card
Entry one button
LED turns on. Press the button on the remote,
work the same.
rolling code series SLH
remote control:
card:
IN THIS INSTALLATION
KOOMAN
www.koomando.com
Brand Selector
for different remote brands. The brands selection is
or remote:
accepts no responsibility
MANUAL ARE SUBJECT
- remote control
learn button Sl, S2 and Ll,
the LED Sl/S2
and cannot be reco-
for incorrect use of
TO CHANGE WITHOUT NOTICE.
DO
store