Introduction; Ranges Of Application - 1A Profi Handels AB01122 Bedienungsanleitung

English 3
Back to Contents

1. IntRoDUCtIon

We would like to congratulate you on the purchase of your airbrush gun. We appreciate your trust. That's why functional security
and operational safety stands on first place for us.
Please read this Instruction Manual carefully and thoroughly before operating the tool to get best performance.
2. In GeneRAl
The airbrush guns are developed according to the newest stand of technology, manufactured with much care and go under strict
intensive controls.
Make sure after unpacking that the data given on the type label match with the included operating instructions. In the case of
doubt is not to be used. Transport damages are immediately to be reported to the package distributor on the shipping invoice and
to us in written form.

3. RAnGeS oF APPlICAtIon

Airbrush guns can be used in:
l hobbies/models
l Bodypainting
l Fingernail painting
l cosmetic
l craftwork spraying
l And much more
The airbrush gun can be also used for providing air source for medical, environment protect, breed aquatics Indnstrial, food
Industrial, chemical industrial, laboratory and so on.
4. oPeRAtIon DIReCtoRY / tRoUBleSHootInG
The Original air hose have rubber airproof inside; the user can make the airtight by hand, and get good performance. If the air
hose is not original, usually the air hose and air compressor cannot be well airproof. If the air hose should not be tight, this will
affect the auto-stop function of the compressor and the spray pattern negatively. Then turn off the compressor and check the
gauge. However, 100% airtight is only effective for auto stop function air compressor. Teflon tape can be used to prevent leakage.
Connect the air compressor, air hose and airbrush gun (or other air tools), plug into the mains supply, turn on the switch, and then
the air compressor will start work. The gauge will show the max pressure, and you can adjust the working pressure by adjusting
the pressure adjustor (only for models with pressure gauge and pressure regulator).
Checking the air leakage. Please do not use the air to pressure reach the max pressure (auto stop function), for the compressors
do not have auto stop function, please turn off the switch. Then check the needle of pressure gauge, if the needle on gauge is very
steady, it is means the airtight is verv good. If the needle decline down quickly, it means there is air leakage in some place of
connection. Please check and make it airtight. Or any small leakage will affect the performance of the compressor. (lt may lead to
frequently auto stop and auto start)
A compressors maximum pressure is the highest pressure it can build up. When a connected airbrush gun is opened, it is preci-
sely with this pressure that compresssed air in itially shoots out through the airbrush nozzle. In contrast, the working pressure is
the constant pressure the compressor can maintain during airbrushing. The level of this working pressure depends, on the other
hand. the nozzle diameter of the airbrush to which it is connected; the larger the nozzle diameter, the greater the amount of air
wich can escape and the lower the compressor's working pressure.