Werbung
Verfügbare Sprachen
Verfügbare Sprachen
REF. 60037
Inserting staples or nails into the magazine
WARNING! Do not place fasteners of different length. Do
not place staples and nails mixed together.
1.
Remove battery pack from the tool.
2.
Press the release button and pull out the magazine co-
ver.
3.
Tilt the tool and place nails/staples into the track of the
magazine channel:
Load staples on the top of the
magazine.
Staples are placed against
the profiled side of the rail; the
crown of the staple is in the
uppermost part of the magazine
(legs are facing away from the
body of the tool).
4.
Close the magazine cover until it engages with the re-
lease button.
5.
Reattach battery pack to the tool.
Nailing and stapling
NOTE! Prior to operation, make sure battery is fully charged
and fasteners are placed in the magazine correctly.
NOTE! During operation, you must hold the handle firmly with
the magazine flat to the work piece forming a 90º angle.
The drive shift knob allows to select between the single and
contact firing mode:
•
Push the drive shift to the left side to set it on the single
firing mode, ideal for precision push placement.
•
Push the drive shift to the right side to set it on the con-
tact firing mode, ideal for a quickly and convenient firing.
Single firing mode
1.
Push the drive shift to the left side.
2.
Depress the safety contact pin against the workpiece.
3.
Squeeze the trigger to fire the staple or nail.
4.
Release the trigger and the safety contact pin after firing.
5.
To fire the next staple or nail, repeat steps 2 and 3.
Load the nails at the end of the
magazine.
Nails are placed against the
profiled side of the rail, with
the points of the nails facing
downwards.
· 7 ·
NOTE! The safety contact pin must be depressed before the
trigger is squeezed.
Contact firing mode
1.
Push the drive shift to the right side.
2.
Squeeze the trigger and keep it pressed, do not release
it.
3.
Depress the safety contact pin against the work piece to
fire the nail or staple.
4.
Keep squeezing the trigger all the time but release the
safety contact pin after firing.
5.
To fire the next staple or nail, repeat step 3.
IMPORTANT NOTES!
•
The trigger must be depressed all the time while the sa-
fety contact pin is being depressed time by time.
•
Do not keep the trigger depressed when the tool is not in
use to prevent accidental firing.
Depth adjustment wheel
The adjustment wheel can be used to set the desired firing dep-
th, which helps protect surface and allows a proper setting of
nail heads:
•
Turn the depth adjustment wheel downwards to
nail/staple will be fired into wood in a much more depth
•
Turn the depth adjustment wheel upwards to
staple will be fired into wood in less depth
Removing a jammed nail or staple
NOTE! You must remove any jammed nail/staple before using
the tool any further.
1.
Remove the battery from the tool.
2.
Open the magazine and remove the staples or nails in
the channel.
3.
Remove the jammed fasteners.
If the fasteners remain jammed after trying above instructions
and cannot be removed:
1.
Open the nosepiece with pull force and remove the jam-
med fastener pieces. You can use pliers if necessary.
, the
, the nail/
Werbung
