HP StorageWorks
Modular Smart Array 1510i
2-Port Ethernet iSCSI module
installation instructions
© Copyright 2005-2006 Hewlett-Packard Development Company, L.P.
Second edition February 2006
Product names mentioned herein may be trademarks of their respective
companies as reflected by an associated footnote.
Information in this document is subject to change without notice.
Printed in the US.
www.hp.com
*383077-022*
383077-022
English
About this document
This document details procedures for installing a redundant 2-Port Ethernet
iSCSI module in an HP StorageWorks MSA1510i.
Before you begin
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. See documentation shipped with your system for
additional information.
NOTE:
You can hot-add redundant components to the MSA1510i.
Removing power from the device is not required.
IMPORTANT:
To obtain 1000BaseT performance from the MSA1510i,
use qualified Category 5e (or better) Ethernet cables to connect the Ethernet
iSCSI module to the network switch. In addition, to prevent the signal
degradation possible with long cables, use a short cable to connect network
devices.
Installing the redundant module
1.
Lift the port-colored latch (1) on the Ethernet iSCSI module blank, and then
pull the blank straight out of the chassis (2).
2
2.
Slide the redundant Ethernet iSCSI module into the vacant bay until the
port-colored latch clicks into place.
2
Verifying module status
Verify that the Status LED at the top of the module is solid green.
Additional information
See the MSA1510i-related documents on the MSA1510i web site:
http://h18006.www1.hp.com/products/storageworks/msa1510i
1
15175
15176
.