Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
See pages 32 and 33 for figures of this unit. oA
SAFEGUARD
Electrical energy can perform many useful functions. This unit has been engineered and manufactured to assure
your personal safety. Improper use can result in potential electrical shock or fire hazards. In order not to defeat
the safeguards, observe the following instructions for its installation, use and servicing.
|
INSTALLATION
When installing the HGE-77 choose a place that satisfies
the following conditions.
1. Install it in a place out of direct sunlight and away
from stoves, etc.
See pages 32 and 33 for figures of this unit.
@) Equalizer controls/indicators
The audio frequency band (20 Hz— 20 kHz) is divided
into 10 bands, the controls providing a continuous
variation of + 10 dB about the center frequency of
each band. When a control is raised, the correspon-
ding frequency range is boosted, and when the con-
trol is lowered, it is attenuated.
For
details,
see
'Points
Regarding
Tone
Adjustment' (page 4).
When the controls are in the ''O"' (click) position, a
roughly flat response is obtained.
Note: If the Equalizer switch G) is OFF (11), the
tonal characteristics cannot be adjusted by mov-
ing the equalizer control knobs.
(2) Spectrum analyzer
The spectrum
analyser displays the signal level in
each frequency band, enabling you to check the fre-
quency distribution visually. You can also check the
effect of the equalizer.
(3) Tape monitor switch
OF naenss: Set
to
OFF
when
not
playing
back
(monitoring)
from
the tape deck
con-
nected.
ON: japeenas Set to ON when playing back (monitor-
Note:
When
playing
back
a tape through
the
graphic equalizer, press the recording switch @)
OFF { [1 ).
() Equalizer switch
ORF wccassks A flat frequency
response
is obtained
regardless of the position of the equalizer
controls.
OWN 58 tS ste Set to this position for adjusting sound
quality with the graphic equalizer.
By turning this switch ON—OFF, you can check the
effect of the graphic equalizer.
(6) Power stand-by switch
When this switch is set to"
| " (a),
power is
supplied to the unit and the equalizer control LED in-
dicator lights up. The unit has a built-in muting cir-
cuit, so that it begins to operate normally about one
second
after
power
has
been
switched
"
. =
( om ).
Note: You can use the tape deck without using
the
graphic
equalizer,
even
when
the
Power
stand-by switch @) is "' (!) " ( T1).
In this case, set the tape monitor switch (@) as
follows:
When playing back a tape: ON ( = )
ing) from the tape deck connected.
Tape Monitor
When using a 3 head tape deck (erase, record and
Multi voltage unit
playback heads all independent),
the sound
to be
@ Voltage selector
recorded can be compared instantaneously with the
(8) AC outlet
sound which has been recorded. This check on the
quality of the recorded sound is known as the tape
@) Power supply cord
When recording a tape: OFF ( [1 )
monitor.
a0) TAPE-PLAY jacks
() Recording switch
@t) TAPE-REC jacks
O Fi aissses: When
recording a source which is not
42 LINE-OUT jacks
passed through the graphic equalizer.
@3) LINE-IN jacks
ON vortasenes When recording a source after passing it
through the graphic equalizer
OPERATION
EQUALIZER
1. Set the input selector of the stereo amplifier to the
2. Set the tape monitor switch on the stereo amplifier to
source desired.
ON (TAPE).
Werbung
