Functions Of The Light - FLINQ FQC8297 Handbuch

EN Manual
Install the motion sensor light
Note: Please check whether the battery is fully charged for the first use.
1 Place magnet
Place the magnet in the right
place with the supplied 3M tape.
3 Place the light
Now place the light on to them
adhesive base.
2 Place magnetic base
Place the adhesive base on to
the magnet.
120°
4 Ready for use
The motion sensor light is now
ready for use. You can rotate the
light 120°.
FlinQ Adjustable LED Motion Sensor Light

Functions of the light

Press the on / off button on the side of the light
On
- First press
Warm light
- Second press
- Press 2 times (third & fourth press)
- Hold the button
Natural light
- Fifth press
- Press 2 times (sixth & seventh press) Light is always on
- Hold the button
Cold light
- Eight press
- Press 2 times (ninth & tenth press)
- Hold the button
Off
- Eleventh press
Note: Built-in sensing components, in a bright environment, the sensing
state does not turn on the light.
Charging the light
Charging: red light
Charging complete: green light
Turn on the light
Sensor mode (light flashes)
Light is always on
Dimming the light
Sensor mode (light flashes)
Dimming the light
Sensor mode (light flashes)
Light is always on
Dimming the light
Turn off the light