Sealife Sea Dragon Mini 900 Montageanleitung

Sea Dragon Mini 900 Underwater Light
Step 1: Unscrew light head from grip and install one 18650-type rechargeable Li-ion battery or two single-use CR123
batteries. Batteries sold seperately. Recommend XTAR brand 18650 battery 3500mAh for best performance.
Step 2: Long press the power
button to power light on and off.
Note: Quick press power button to
change 5 different light modes:
100% power → 50% power →25%
power → Blinking → SOS → repeat
cycle .
Optional mounting adapters
The Mini 900 light may be mounted to any YS
mounting system, Flex-Connect mounting system or to
any UW housing cold shoe using the following
adapters:
A B
A) YS Adapter for Sea Dragon Mini 900 (Item #
SL98104). Mount light to any YS arm or adapter.
B) Flex-Connect YS adapter (SL994). Mount light to
Flex-Connect arm, grip or adapter when combined
with YS adapter "A".
C) Flex-Connect Cold Shoe (SL991). Mount light to
UW housing cold shoe when combined with YS
adapter "A" and Flex-Connect YS adapter "B"
SeaLife (Div. of Pioneer Research), 97 Foster Road, Moorestown, NJ 08057 USA
(Item SL653)
Step 3: The light uses two O-rings to maintain a waterproof seal.
1) O-rings and sealing surfaces must be perfectly clean.
2) Inspect O-rings for cuts, tears or other damage and replace if damaged or
at least once a year (item SL65301).
3) Lube O-rings lightly before each use.
Important:
1) After each dive, soak the sealed light in fresh water for
about 20 minutes to remove any residual salt, sand
and dirt. Dry light with clean towel before opening
battery compartment or storage.
2) A battery indicator light is located around power
button. Green = full power, yellow = half power and
red = low power (Replace/recharge battery).
3) Do not use rechargeable CR123 batteries.
4) Minimum requirements for 18650 battery: Button cell
top; Integrated protected circuitry; Minimum 2600
C
mAh; Minimum 3.5A discharge current; Cell made in
Japan by reputable brand like Panasonic/Sanyo or
Samsung.
Guarantee:
for a period of one (1) year from the date of purchase, that the product
is free from defects in workmanship and materials. In the event the
original purchaser believes there is a defect in a product, it is
recommended that the purchaser first visit www.sealife-cameras.com
for product updates and information on how to get warranty repair
service. Please contact your local SeaLife dealer or the importer in the
country where the product was purchased for return information.
September 2017
Instruction Sheet
SeaLife warrants the original purchaser of this product,
www.sealife-cameras.com