Eurotops 51198 Bedienungsanleitung

Art. No. 51198 Illuminated sandart
INSTRUCTIONS
The sand painting rotates 180 degrees, allowing air to flow through the bottomn of the sand, and you
can enjoy the fascinating image of the falling sand. Because bubbles and quicksand change randomly,
the picture will be different each time, and the two pictures will not repeat exactly the same. hen the
quicksand completely settles down to the bottom,it stays still for 30 minutes, and then turns over again
to get a different picture.
Maintenance and air conditioning of quicksand art
As the temperature and pressure change, sometimes you will need to adjust the air and water.
There are air conditioning holes (circular holes) on the top or both sides of each quick sand painting.The
quicksand art is a natural balance of water,sand and air. The height of air layer is about 1cm, and the
sand will reach a relatively good flow rate.
Note: The air layer has been well balanced before delivery. In general, thereis no need to adjust the
air and water.
Precautions when inserting the stoma
The air is located between two pieces of glass, the diameter is about 1mm，such as when inserting a
hard object can not be inserted, it means that there is no hole inserted, do not insert hard at this time,
otherwise it will lead to the deformation of the regulator needle, can re-select the appropriate positior
for testing, until the regulator can be easily inserted.
The quicksand falls too slowly, pulls out some air
1. There is a vent at the top or side of each quicksand art frame. Concentrateair into any vent and move
the sand away.
2. Insert the air hole with the regulator and add some air.
The quicksand falls too fast, add some air
1. In the same way as above, concentratethe air into any of the pores and move the sand away.
2. Insert the air hole with the regulator and draw out some air.
If the many small bubbles in the quicksand layer become a particularlylarge bubble, a little water
can be filled at this time to supplement theevaporation of water.
1. Be sure to use pure water.
2. Select a air hole, remove the sand, draw out some air, and empty the regulatotube.
3. Use the regulator to pump in and add the same amount of water. Be careful not to add too much
water at once, lest the pressure is too highand the glass will break.