Lavor EG-MS 3800 Gebrauchsanleitung Seite 35

6) Battery tool use and care
a) Recharge only with the charger specified
by the manufacturer. A charger that is
suitable for one type of battery pack may
create a risk of fire when used with another
battery pack.
b) Use power tools only with specifically
designated battery packs. Use of any other
battery packs may create a risk of injury and
fire.
c) When battery pack is not in use, keep it
away from other metal objects, like paper
clips, coins, keys, nails, screws or other
small metal objects, that can make a
connection from one terminal to another.
Shorting the battery terminals together may
cause burns or a fire.
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
When using the pump, always observe the
following safety instructions.
Before use check the pump for damage.
n
Should the pump be damaged, it must not be
used.
Only connect the pump to an electric group
n
which is protected with an earth leakage
switch (30 mA).
Do not use the pump in swimming pools or other
n
places where persons could find themselves in
the vicinity of the pump in the water.
Do not use the pump in fish ponds or fountains.
n
Never use the pump if no outlet pipe of min.
n
20 cm has been fitted.
If the pump is used for pumping drinking water,
n
the installation must be rinsed thoroughly.
Never let the pump run dry.
n
Always remove the mains plug from the wall
n
socket before moving or servicing the pump.
Never pull an attached water hose to move
n
the machine.
If the tank leaks, switch off the machine
n
immediately. Have the machine repaired by
an authorised technician.
Make sure that the machine is switched off
n
and unplugged and that the tank is pressure
free before troubleshooting or servicing, or
when the machine is not used.
The moist collected in the tank must be drained.
n
Not bleeding the tank can lead to leakage and
may cause a dangerous situation.
The following symbols are used throughout this
manual:
@
Denotes risk of personal injury or
damage to the machine.
ELECTRICAL SAfETY
@
Always check that the power
supply corresponds to the voltage
on the rating plate.
DESCRIPTION (fIG. A)
Your water pump has been designed to pump
clean water. The machine is not suitable for
pumping salt water. The maximum water
temperature is 35 °C.
1 On/off switch
2 Mounting holes
3 Pump housing
4 Drain hose connection
5 Filling point
6 Supply hose connection
7 Tank
8 Manometer water pressure
9 Pressure regulator
10 Adjustment knob water pressure
11 Bleeding point
Positioning the pump (fig. A)
Place the machine on a flat, stable underground.
n
Make sure that the machine is not positioned
9 m higher than the level of the liquid to be
pumped.
Connect the supply and drain hoses. Mount
n
the supply hose to connection (6) and the
drain hose to connection (4).
GB
35