YI Dome X Bedienungsanleitung Seite 22

All manuals and user guides at all-guides.com
This device complies with Part 15 of the FCC Rules / Industry Canada licence-
exempt RSS standard(s). Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Le pr é sent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autoris ée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Under Industry Canada regulations, this radio transmitter may only operate
using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conform é ment à la r é glementation d'Industrie Canada, le pr é sent é metteur radio
peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inf é rieur) approuv é
pour l é ' metteur par Industrie Canada. Dans le but de r é duire les risques de brouillage
radio é lectriqueà l 'intention des autres utilisateurs, il faut choisir le type d'antenne et son
gain de sorte que la puissance isotrope rayonn é e é quivalente (p.i.r.e.) ne d é passe pas
l'intensit é n écessaire à l'établissement d'une communication satisfaisante.
MPE Requirements
To satisfy FCC / IC RF exposure requirements, a separation distance
of 20 cm or more should be maintained between the antenna of this device and
persons during device operation.To ensure compliance, operations at closer than this
distance is not recommended.
Les antennes installées doivent être situ é es de facon à ce que la population ne
puissey être expos é e à une distance de moin de 20 cm. Installer les antennes de
facon à ceque le personnel ne puisse approcher à 20 cm ou moins de la position
centrale de l'antenne.
La FCC des éltats-unis stipule que cet appareil doit être en tout temps é loign é d'
au moins 20 cm des personnes pendant son functionnement.
FCC ID: 2AFIB-YYS3017
IC: 20436-YYS3017