Fisher EQ-274 Bedienungsanleitung Seite 14

Connections on the Rear Panel (Fig. 4)
41. LINE Cables by
The item "technical description" of this manual provides
information on the various connection possibilities.
2. TAPE Deck Connections -
(only for connection method 2)
Connect the tape
recorder
or cassette recorder
for
recording (REC) and playback (PB) with these connec-
tion jacks.
3. ACSELECTOR Switch
This unit has been
factory-adjusted
for operation
on
220VAC. The voltage can be changed for operation on
1410VAC by making the following changes to the AC
selector:
— Remove the AC plug from the wall outlet.
— Remove the screw holding the switch safety plate.
— Replace the screw without the safety plate and tighten
it.
DO NOT remove both screws at the same time!
4. AC (Power Cable)
After completing installation and all connections, place
the plug in a wall outlet with the proper AC voltage.
Connections and Operating Information
Selection of the proper connection method
Please refer to the item "technical description" of this manual
for information
on which
of the three possible connection
methods would be best for you.
Basic adjustments to Equalizer
— £Q.REC/OFF switch in the OFF position.
— TAPE MONITOR. switch in the SOURCE position.
if you want to adjust the sound impression
to the room acoustics
~ EQ. ON/OFF switch in the ON position. The EQUALIZER
indicator and the graphic equalizer indicators will light.
— Turn volume control on the amplifier up slightly.
— Adjust the position of the 20 slide controls according to
personal taste and environment.
If you want to correct sound deficiencies
of the loudspeakers
Follow the instructions of the previous paragraph. Do not
forget, however, that small loudspeakers can be overloaded
by high amplifier power and powerful bass. boosting. The ,
same applies to strong treble boosting with a high listening
volume.
If you want to correct deficiencies of a reproduction
- £Q. ON/OFF switch in the ON position. The EQUALIZER
indicator and the graphic equalizer indicators will light.
— Try to perceive the sound deficiencies (rustling,
rumbling, lack of treble, lack of bass etc).
— Try out the effect of various slide controls on the sound
impression. You can gain useful knowledge by trial and
error.
— The EQ. ON/OFF switch proves its value when one
directly compares the quality of sound impression of a
corrected reproduction and the original.
If you want to make cassette or tape recordings
a) Without Equalizer: use the recording unit as usual
b) With Equalizer: (only possible if you have chosen con-
nection method 2. See "technical description."
— Depress the EQ. REC/OFF switch to REC. The EQ.
REC indicator and the graphic equalizer indicators
will light.
— Use the recording unit as normal.
— If you have a unit with 3 heads: you can listen to the
recording with the TAPE MONITOR switch in the
TAPE position.
CAUTION: With some tape recorders and cassette units, the
record level indicator is technically not in a position to give an
accurate record level indication with recordings over the
equalizer. If distortions can be heard with stronger frequency
response corrections of the program being recorded, the
recording has been made at too high a level.
if you want to play cassette or tape recordings
a) Connection method ia and 1b: use the tape or cassette
recorder as usual
b) Connection method 2:
~— Depress the TAPE MONITOR switch. The TAPE
MONITOR indicator will light.
— Use the tape or cassette recorder as normal.