Soundcore VR P10 Bedienungsanleitung Seite 4

DUAL CONNECTION
Dongle
The earbuds can connect with two devices (via dongle or Bluetooth) at the
same time.
You can only play music from one device at a time.
If you have an incoming call on the Bluetooth device, you can hear from
both connected devices at the same, but the volume on the dongle-
connected device will be lower than that on the Bluetooth device.
CONTROLS
Play / Pause
Next track
Volume up
Volume down
Mono mode: You can use either one of the earbuds only by putting
the other one back into the charging case.
Stereo Mode: When in mono mode, take out the other earbud from
the charging case, the two earbuds will automatically switch to stereo
mode.
PLAYING WHILE CHARGING
You need a charger that supports USB PD (Power Delivery) and has
a minimum output of 9V/2A, otherwise this function might not work
properly.
*No data transmission is supported. Don't try to link a PC to a VR
headset using a USB-C cable.
Bluetooth
1
3s
Tap twice (R)
Tap twice (L)
Tap once (R)
Tap once (L)
CONTROLS
2
soundcore
VR P10
soundcore
VR P10
• In the soundcore app, you can customize the controls, e.g. enable a
single tap to adjust volume.
• Controls may vary when connected via the dongle if the console's
system is incompatible.
• Adjust the volume level via the connected device or in the
soundcore app.
(via Bluetooth)
(via Dongle)
VR LINKING TO PC
1
1. Connect the link cable from a USB-C port on your PC to your VR
headset.
2. Plug the dongle into another USB-C port on your PC to use your
soundcore earbuds.
EN 04
×2 ×2
R L
×2
L/R L/R
Voice
Assistant
L/R
2s 2s
Answer a call Tap twice (L/R)
Tap and hold for 2
Reject / End a call
seconds (L/R)
Tap and hold for 2
End a call
seconds (L/R)
Activate Siri or other Tap and hold for 2
voice assistant software seconds (L/R)
Dongle
L/R
2s 2s 2s 2s
2