KERN FEJ-A05 Installationsanleitung Seite 12

4 Assembly
The assembly described refers to the scale and stand as delivered. If you
have already mounted the scale with the terminal, for example, you must
remove it again.
1. Remove the weighing plate from the scale.
2. Loosen the 3 screws [3] on the back of the terminal [1].
3. Loosen the 6 screws [7] of the stand cover [6] and lead the scale cable [5]
through the stand [2].
4. Guide the scale cable [5] through the cable clamp [4] and fasten the cable
clamp on the back of the stand [2] with the screw.
Make sure that the scale cable is not taut between the cable clamp and
the terminal, but loose enough so that you can adjust the display angle
of the terminal later.
5. Reattach the stand cover [6] to the stand [2] with the screws [7].
6. Attach the terminal [1] to the stand [2] and fasten it with the 3 screws [3].
Hint:
 Slightly screw the top screw with washer into the terminal before
attaching the terminal to the stand.
 Place the stand with the upper recess (A) on the screw of the terminal.
 Slide the stand onto the terminal so that the holes of the terminal are
congruent with the positions C of the stand.
 Screw in the other screws with washers and tighten all 3 screws.
3 TFEJ-A05-A-IA-def-2210