Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.4 Handling Rechargeable Batteries
Keep rechargeable batteries out of the reach of children. Always keep rechargeable batter-
ies out of the reach of children.
Do not leave rechargeable batteries lying around openly. Children or pets may swallow
them. In such a case, call a doctor immediately!
Rechargeable batteries must never be short-circuited, taken apart or thrown into fire. There
is a risk of fire and explosion!
If your skin comes into contact with leaking or damaged rechargeable batteries, you may
suffer burns. Thus you should use suitable protective gloves.
If any rechargeable battery connector cables need to be cut to size (e.g. if the rechargeable
battery is supplied without a connector plug), cut each cable individually to prevent a short
circuit occurring. Risk of fire and explosion!
Use the charger to charge only the rechargeable batteries with appropriate technology
(LiPo). Never use this device to charge other types of rechargeable batteries or non-re-
chargeable batteries. There is a risk of fire and explosion!
Non-rechargeable batteries are meant to be used once only and must be disposed of when
empty. Charge rechargeable batteries intended for that use only.
Batteries must not get damp or wet.
Never damage the exterior of a rechargeable battery. There is a risk of fire and explosion!
Never charge/discharge rechargeable batteries unattended.
Never charge/discharge a rechargeable battery directly in the model. First, remove the
battery from the model, disconnect it totally from speed or flight controller.
Please observe the correct polarity (plus/+ and minus/-) when inserting the rechargeable
battery into the charger or into the model (for e.g. an autopilot). Should you connect the
rechargeable battery incorrectly, not only will the model be damaged but also the recharge-
able battery. There is a risk of fire and explosion!
Do not charge any rechargeable battery that is still hot (e.g. caused by high charge current
from the model). Allow the rechargeable battery to cool down to room temperature before
attempting to charge it again.
Never charge/discharge damaged, leaking or deformed rechargeable batteries. This can
result in a fire or explosion! Dispose such unusable rechargeable batteries in an environ-
mentally compatible manner.
Never use a LiPo rechargeable battery composed of different types of cells.
Recharge the rechargeable batteries about every 3 months, as otherwise there may be
a total discharge due to self-discharge, which makes the rechargeable batteries useless.
Disconnect the rechargeable battery from the charger when the rechargeable battery is
fully charged.
Improper use (too high charging current or incorrect polarity) can supercharge or damage
the rechargeable battery. In the worst case, the rechargeable battery can explode and
thereby cause serious damage.
Never damage the rechargeable battery, never let the rechargeable battery fall, do not
pierce the rechargeable battery with any objects! Avoid applying any mechanical loads to
the rechargeable battery, never pull on the battery's connector cables! There is a risk of
fire and explosion!
These guidelines must also be observed when the rechargeable battery is inserted into the
model (if the model is removed, for example).
Ensure that the rechargeable battery does not overheat during usage, recharging, dis-
charging, transport or storage. Do not place the rechargeable battery adjacent to sources
of heat (e.g. cruise control, motor), keep the rechargeable battery away from direct sunlight.
There is a risk of fire and explosion if the rechargeable battery overheats!
The rechargeable battery must not reach a temperature higher than 60°C (observe ad-
ditional instructions of the manufacturer with other limitations as applicable!).
If there are damages on the rechargeable battery, do not use it any more. Do not recharge
it. There is a risk of fire and explosion!
Only touch the rechargeable battery with care, use suitable protective gloves.
Dispose of the rechargeable battery in an environmentally compatible manner.
If the rechargeable battery manufacturer provides no information as to maximum permis-
sible charge current, charge the LiPo rechargeable battery with the maximum current of
1C. This means that the charging current may not exceed the capacity value imprinted
on the rechargeable battery (e.g. rechargeable battery capacity 1000 mAh, max. charging
current 1000 mA = 1 A).
Observe the additional safety instructions from the manufacturer of the rechargeable bat-
teries/battery packs that you use.
6 Connections and Control Elements
1. Mains supply socket
2. XH jacks for connecting a LiPo rechargeable battery
3. Power LED
4. Status LED
Only connect one single rechargeable battery to the charger at a time. Always use
only one of the XH jacks at a time.
If more than one rechargeable battery is connected to the charger, both the
charger and rechargeable battery can be damaged!
7 Installation and Operation
Do not modify or repair mains supply components including mains plugs, mains
cables, and power supplies. Do not use damaged components. Risk of death by
electric shock!
Connect the power socket (1) to an appropriate mains socket via the supplied power cable.
The Power LED (3) lights up green when the charger is ready for operation.
Place the charger on a level, flat, stable surface. Protect valuable furniture surfaces by us-
ing a suitable mat to prevent scratches, pressure points or discolourations.
The casing of the charger heats up during operation. Therefore make sure that the charger
is always adequately ventilated; never cover it while in operation.
Disconnect the LiPo rechargeable battery from the speed or flight controller.
Connect the rechargeable battery to be charged via its XH balancer plug with the relevant
jack (2) of the charger. At that, observe the correct polarity of the XH plug. When connect-
ing, do not use excessive force; always use a socket matching the jack.
If your rechargeable battery has a balancer connector with other plug type than
XH, there will be a matching adapter in the accessories trade.
Only connect one single rechargeable battery to the charger at a time. Always use
only one of the XH jacks at a time.
Please note that only a LiPo rechargeable battery of serial configuration can be
charged (marked e.g. as 2S or 3S).
Special rechargeable batteries with e.g. connectors of both cells led out separately
cannot be charged by this charger.
The charger starts the charging process and charges the LiPo rechargeable battery via its
balancer connector. Adaptation of the cell voltages occurs at the same time, so that all cells
have the same voltage after the charging process is completed (insignificant deviations
depend on technical factors).
The charging current or capacity of the charger (see chapter "Technical Data")
is divided to cells depending on their number. The more cells the connected re-
chargeable battery has, the longer is the charging process.
A status LED (4) indicates the function of the charger:
LED is off:
No rechargeable battery connected/identified
LED lights up red:
The charging process is under way
LED lights up green:
The charging process is finished
LED flashes red:
An error is indicated (for e.g. rechargeable battery deeply dis-
charged, cell voltage too high, etc.)
When the charging process is done, remove the rechargeable battery from the charger.
Now, either connect another rechargeable battery for charging, or disconnect the charger
from the mains voltage. Pull the mains plug out of the mains socket. Keep the product in a
cool, dry, dust-free place out of the reach of children.
8 Care and Cleaning
A connected rechargeable battery must be unplugged before cleaning. Disconnect the
charger from the mains voltage. Pull the power plug out of the mains socket.
Do not use abrasive cleaning agents, cleaning alcohol or other chemical solutions, since
these could damage the housing or even impair operation.
Use a dry, lint-free cloth to clean the product.
Werbung
