Eldes EKB3 Installationsanleitung Seite 13

All manuals and user guides at all-guides.com
4. PARTITION CONTROL AND
INDICATIONS
The features described below are only available with the system
ESIM364 and requires keypad partition switch function being
enabled.
EKB3 keypad can operate in one of the following modes:
• 2-partition mode – This parameter determines whether the
keypad can operate only in one of the first two system partitions
allowing to arm/disarm them and switch the keypad partition
using the number keys
default.
• 4-partition mode – This parameter determines whether the
keypad can operate in one of the four system partitions allowing
to arm/disarm them, indicate arm/disarm status, partition state
on number keys
1
the number keys
1
Switching Keypad Partition
To switch the keypad partition, please press and hold key
(2-partition mode) / key
1 2
for 2 seconds to apply the command. Upon the successful keypad
partition change, the keypad buzzer will emit three short beeps.
In Case of Alarm
• 2-partition mode – Red indicator will light ON indicating the
corresponding violated zone number (Z1-Z12) or indicator
flash or light ON indicating the violated high-numbered zone
(Z13 and up) or tamper respectively.
• 4-partition mode – Key
partition that contains violated zone/tamper. By switching to
the violated partition, the keypad will indicate the violated zone/
tamper number as described in "2-partition mode".
Arming and Disarming
To arm the partition the keypad is switched to, please enter a valid
user/master code, assigned to the appropriate partition.
• 2-partition mode – The armed partition number will be
indicated by illuminated indicator
corresponding partition 1 or 2 respectively.
• 4-partition mode – The armed partition number will be
indicated by illuminated key
LED KEYPAD EKB3
. This mode is selected by
1 2
and switch the keypad partition using
4
.
4
(4-partition mode)
1
4
1 will flash, corresponding the
4
on indicators' section A or B
.
1
4
will
EN 13