APLIC 20191008SZ142 Bedienungsanleitung Seite 8

4. Functions
With the HDD docking station, you can read or write up to two hard drives simul-
taneously via one USB port. Due to the convenient clone function, you can backup
data from one hard drive to another.
5. Initial use
Take the device out of the package and remove all the packaging material. When
the device is put into operation for the first time, check the intactness of the prod-
uct or components and their function again. Place the unit on a flat surface. Now
connect one or two hard drives with the appropriate connections. Connect the
included USB cable to the docking station and to your computer or notebook. Con-
nect the 12V power supply to the docking station and then to a properly wired
outlet. Then press the "power" button. The button is located on the front of the
device. After it, the docking station is ready for use.
6. Clone function
Note: The hard disks can get hot during the clone process.
Make sure that the destination hard disk has at least the same size as the hard disk
to be cloned. The destination disk will be completely deleted at the start of the
operation. Please back-up your important data beforehand, if necessary.
Note: Please make sure that the USB 3.0 cable is not connected to your computer
or laptop during the period of cloning.
The hard drive (source) to-be cloned should be plugged into one bay "HDD 1" and
the destination disk into "HDD 2". Turn on the device with the "power" button on
the front.
Press twice in rapid succession the "clone" button on the front of the device
until the clone processing indicator starts flashing (from left to right: 0-100%).
The cloning will start and the LED display shows the cloning process. The cloning
process is completed if the progress indicator reaches 100% and stops flashing.
After a successful "clone" operation, you can connect the docking station to your
computer again. In few cases just one hard disk might be recognised because it
both have the same names and data.
8
English