Werbung
Sunny Cascade
Composants
Le support correspond aux
points indiqués
Fixez la vasque principale
sur le support
1 Panneau solaire
2 Pompe avec le boîtier de crépine
3 Carafe
4 Petites cuvettes
Fixez le tuyau selon les indications
Assemblage et utilisation du produit
Déballez soigneusement tous les éléments.
Il y aura des éclaboussures quand le produit fonctionne.
Assurez-vous que la surface sur laquelle la fontaine est placée
n'en sera pas affectée.
Assemblez d'abord le support de métal recouvert de plastique.
Il y a quatre points de connexion. Insérez d'abord la grande
Le tuyau et le tampon de caoutchouc
cuvette. Assurez-vous qu'elle est correctement alignée.
s'ajustent dans l'orifice sous le pot
Insérez ensuite les petites cuvettes.
Pour attacher le tuyau d´eau à la pompe, ouvrez le boîtier du
filtre, enlevez la pompe et attachez le tuyau a la pompe comme
montré sur l´image.
Déroulez le tuyau et le câble. Tirez le tuyau a travers l´anneau
supérieure et insérez le bondon dans le trou de la cruche et
mettez la cruche sur l´anneau supérieure du statif.
vous que le tuyau poussés approximativement 2,5 cm (1 inch) à
l´intérieur de la cruche.
Le tuyau est poussé environ
Apposez le tuyau au statif en métal en utilisent les petites agrafes
2,5 cmdans la cruche
fourni et mettez la pompe avec boîtier filtre dans la cuvette
principale. Remplissez la cuvette principale avec de l´eau et
alignez la cruche et les petites cuvettes.
Remarque : Nous recommandons d'utiliser de l'eau distillée ou
de l'eau de pluie pour éviter l'accumulation de tartre.
Choisissez une location favorable pour votre panneau solaire et
montez comme montré sur les photos.
Attachez le tuyau à la pompe
Page 12
Manuel d'instructions
5 Cuvette principale
6 Module de support
7 Tuyau avec le bondon
8 Stand
Rassurez
Select a suitable location for you solar panel and fix the mounting
as shown. Connect the panel and pump together.
IMPORTANT
To ensure the seal remains water-tight twist the pump and panels
connectors together rather than merely pressing them together.
Check that the yellow small rubber "o" ring remains in its' groove
and is not pushed out when connecting. If this ring moves there will
be no water seal and the pump and panel will eventually fail.
The Sunny Cascade is now ready to use.
Please note: On first use there maybe air in the pump. It can take
up to 5 minutes until all the air is expelled and water begins to
cascade from the top jug.
Cleaning and Maintenance
Pump: If, after a period of time, the pump starts to lose power or
stops working check for the build up of sediment, scale or dirt in
the filter housing and in the bottom of the pump housing.
Disconnect the solar panel and pump connector and then remove
the pump from the water feature. Open the filter housing and clean
the filter.
Remove the pump cover at it's base, take out the
impeller cover and remove the impeller and then remove any
sediment, scale or dirt that has built up. Replace the impeller,
impeller cover, pump cover and filter housing. Place the pump
back into the water feature and reconnect the solar panel and
pump connector.
Solar panel: The panel should be cleaned periodically with a soft
tissue and proprietary glass cleaning solution. Regular cleaning of
the panel is advised to maintain optimum conversion of the sun's
energy into direct current.
Trouble Shooting
If you have any problems please contact Sunny Pumps before
returning to the place of purchase. For immediate answers visit
our website www.sunny-pumps.com where you will find an
extensive trouble shooting section with frequently asked
questions, instant email enquiry forms and place spare part
orders.
Pump does not operate even though the solar panel is in full
sunlight
Check whether the impeller is blocked by removing the pump
cover and impeller cover. If it is, then clean the pump as detailed
above. If it is not, contact Sunny Pumps for further assistance.
Pump does operate but there is no water running through the
hose
1) Check for the build up of sediment, scale or dirt in the filter and
in the bottom of the pump housing as detailed above.
2) Check whether the pump cover and impeller cover are attached
properly. If the pump and impeller covers are not pushed down
tightly, the pump will not push water through the fountain.
ENGLISH
Solar panel & Stand Kit
Fixing the Panel Holder
Wall Mounted Solar Panel
Stand Mounted Solar Panel
Standing Solar Panel
Page 5
Werbung
Kapitel
