Toolland TM 76005 Gebrauchsanweisung Seite 10

TM 76005
INSERTING AND REMOVING A DRILL OR
SCREW BIT (FIG A)

Open the chuck (7).

Insert the drill or the screw bit in the
chuck.

Fasten the chuck by hand.

Fasten the chuck firmly by inserting the
chuck key in one of the holes in the side
of the chuck and turning it clockwise.

In order to remove a drill or screw bit,
you proceed in reverse order.
Before inserting or removing a drill
or screw bit always pull the plug
from the wall socket.
MOUNTING THE SIDE GRIP (FIG A)

Loosen the side grip (6)

Slide the side grip (6) over the chuck and
onto the machine.

Turn the side grip into the required
position and tighten it firmly.
MOUNTING THE DEPTH STOP (FIG A)
The depth stop is used to limit the maximum
drilling depth.

Loosen the side grip (6).

Insert the depth stop (8) into the hole in
the side grip.

Set the depth stop to the required drilling
depth.

Tighten the side grip firmly.
SELECTING THE OPERATING MODE (FIG
A)
Select the required operating mode before
use (drilling or hammer drilling).

For drilling in wood, metal, plastics and
soft stone and for driving screws, turn
the drill symbol on the switch (5) to the
arrow.

For drilling in masonry, turn the hammer
and drill symbol on the switch (5) to the
arrow.
Always wait until the motor has
come to a complete standstill
before changing the operating
mode.
FORWARD/REVERSE SWITCH (FIG A)

Push the forward/reverse switch (4) to
the left to drill holes and fasten screws.
www.toolland.eu

Push the forward/reverse switch (4) to
the right loosens screws.
Always wait until the motor has
come to a complete standstill
before changing the direction of
rotation.
ADJUSTING THE SPEED (FIG A)
This machine has been fitted with an
adjusting wheel (2) for the maximum speed.

Turn the adjusting wheel (2) as indicated
on switch (1) to set the maximum speed.
SWITCHING ON AND OFF (FIG A)

To switch the machine on, press the
on/off switch (1). The further you press
the switch, the higher the speed of the
machine.

To switch off the machine, release the
on/off switch (1).

To switch the machine to continuous
mode, keep the on/off switch (1) pressed
and at the same time press the lock-
on/off switch.

To switch off continuous mode, press the
on/off switch (1) again.
TECHNICAL SPECIFICATIONS
Voltage
Frequency
Power
Speed (no load)
Impact (no load)
Drilling capacity
Wood
Steel
Concrete
Weight
Level of sound pressure measured according
to EN-standards:
Lpa (sound pressure)
Lwa (acoustic power)
Weighted root mean square acceleration
value according to EN:
English
230V
50Hz
500W
2800t/min
44.800t/min
25mm
10mm
13mm
1,8kg
98 dB(A)
111 dB(A)
6m/s²
10