Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DB25 male connector:
1:
X input +
2:
Y input +
5:
Red +
6:
Green +
7:
Blue +
14:
X input -
15:
Y input -
18:
Red –
19:
Green –
20:
Blue -
25:
Ground
All signals are available also on the DB25 female connector, for wiring the control signals to
a second projector.
Adjusting projection size
Just next to the ILDA connector, you will find projection size adjustments, and mirror
switches, to mirror each projection axis in case of rear projection, or upside down mounting.
The functions are self explaining.
Connecting to power
The internal power supplies are multi voltage switching power supplies, and will adapt to
almost any power source on the planet. Use a standard power cord. No switching is necessary.
For US countries, or other countries with low AC voltage, a different fuse might be necessary.
In this case, replace the 2A fuse with a 4A type.
Scanfail safety circuit
All Midget projectors are equipped with a fast scanfail safety device, according to EN/IEC
60825-1. It monitors the galvo movements, and shuts off laser beams within a very short time,
if a scanfail is detected, or if both galvos stand still without movement. It cannot protect
incorrect or dangerous show programming.
C by MediaLas Electronics
www.medialas.com
Werbung
