Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Step-by-Step Guide for the Antenna Installation
1. Find a suitable position on the roof of your vehicle. Please
ensure that you have selected the correct position suitable
for the hole into the vehicle's interior and that it is suitable for
the cable entry and is clear of any obstructions. Cabinets and
cupboards are usually a preference to ensure a tidy installation.
2. Drill a pilot hole from the ceiling to the roof.
3. Drill with a 20mm hole saw just enough to break the surface of
the ceiling.
4. Drill from the roof down to get a straight and clean hole. Check
the hole is straight by drilling one last time from inside
5. Clean the roof of the vehicle to prepare for the installation of
the 5G antenna.
6. Place the router down (with the sticker intact) to ensure it's
straight. Remove the 3m sticker paper.
7. Point the router facing forward by using the grove as your
guide. Apply a generous amount of adhesive to the neck of the
thread to prevent any water from getting into the hole.
8. Drop the cable into the hole.
9. Apply moderate pressure to get the 3M tape to stick to the roof.
10. Pass the nut through the cables and thread until it reaches the
ceiling. Tighten the nut by hand only.
Step-by-Step Guide for Mounting the Router's Docking
Station
11. The SMA cable from the antenna is 0.5 meters long allowing sufficient
distance to connect the antenna to the router. Fix the docking station
with the 2 small screws.
12. Use the 2-meter 12-volt power cable that comes with the docking
station. Plug the power plug into the docking station. As the distance
to the battery may be longer than 2m you will need to extend a cable
by crimping the cables.
6
Werbung
