GrowMax Water SUPER GROW 800 L/h Bedienungsanleitung Seite 3

SUPER GROW • Setup:
1. Main Unit
2. Garden hose connector
3. Sediment filter
4. Green coconut carbon filter
5. Garden hose connector
Before
Installation/Precaution!
*Note: Do not install the system where the incoming water pressure may
be more than 90psi (6 k/cm2). If unsure, check the pressure with a pressure
gauge, available at your local hardware store. If your water pressure is
more than 90psi (6 k/cm2) install a pressure regulator, available at your
Grow Max Water dealer or hardware store. Do not use with hot water.
How to install the SUPER GROW unit:
1) Begin by connecting your garden hose to the quick connect adaptor
on the inlet (right side) of the system.
2) Connect your garden hose to the quick connect adaptor on the outlet
(left side) of the system.
3) Before using the system you will need to flush out any carbon fines
and particulates. You simply open the water and flush out the system
for 5 minutes letting the water go to the drain.
You are now ready to use your system!
1
5
4
2
3