Changing The Atomizer Head - Adjusting The Air Supply - SC iStick Basic Bedienungsanleitung

SC iStick Basic Set – Using the Device
Changing the Atomizer Head
Separate the atomizer base from the tank of the GS Air 2 clearomizer� The atomizer head is loca-
ted on the base� Just unscrew and replace it� Finally, connect the components together again�
Make sure that the clearomizer is firmly closed� Please also note the information on page 26.
Adjusting the Air Supply
The airflow control is located on the atomizer base� By adjusting the screw it is easily adapta-
ble to your vapor preferences� The more the slot is open, the lower is the drawing resistance�
Pay particular attention to a sufficient air supply during sub-ohm vaping�
31