Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Turning the Display On/Off
Press the Standby button on the remote or on rear left side of the Display to switch it on from standby or to
switch it into standby mode.
LED Status
Power LED not lit
Power LED lit
Power LED flashing (slow)
Power LED flashing (fast)
Connecting the IR Receiver
Before plugging the Display into the mains supply, connect the supplied IR receiver to the IR input on the
Display. Place the IR receiver in sight of your own remote control. Simply operate your remote control whilst
pointed at the IR receiver and it will relay the control signal to your Display.
In case your Display has touch screen feature and if the IR receiver is going to be placed on the Display it
shouldn't be placed facing the inside of the screen, otherwise the signals of the touch screen and the remote
may interfere with each other. To improve the performance of your remote control place the IR receiver as
shown in the drawing below.
Joyst�ck
V+
V-
Status of the monitor
Power on
Power off (Standby mode)
Scheduler active
Power up/down and software update
Front side of the Display
English - 8 -
Werbung
