GRE PREMIUM COVER 1 Montageanleitung

ASSEMBLY SUGGESTIONS: WINTER COVERS
EN
Suggestions for correct positioning: / Installation suggestion
1- Positioning the cover
- Unroll the cover along the width of the pool and centre it.
- Extend the cover over the pool keeping it xed at the angles by placing non-aggressi-
ve heavy weights on the corners.
- If the cover is rectangular, x its 4 corners rst, and distribute the weights around the
perimeter for provisional xing.
2- Fixing the cover
- Drill 6mm holes x 70 mm depth at a distance of 40 cm from the angles at their diago-
nal.
- Lay a cord between the end holes in order to align them situating it exactly in the
middle of the eyelets at 30 cm form the edge of the cover.
- Pass through the eyelets.
- Adjust the tension balancing the traction forces between the xing points.
- Do not over-tighten the perimeter cord; we suggest leaving some play in its tension.
For easy installation of the winter cover, we suggest leaving the isothermal cover on
the pool and remove it just before xing the last edge next to the roller.
Swivelling anchor points: follow the same steps, previously drilling
12 mm holes to 70 mm depth.
Hooks for cord: Fix the hooks with screws 5 x 30 mm diameter (not
supplied) under the wooden surrounding edge so the cord is
su ciently tight.
Important: Check that the thickness of the wood is enough to not
perforate or damage the liner with the screws.
OPTION:
Eyelet
Hooks
Holes
for water
evacuation
Contents of packet:
- Winter cover
- Fixing accessories: swivelling anchor
points or stainless steel hooks, and the
perimeter cord.
This cover is not in conformity with
the obligations of the NF P90-308
standard. It is not a safety cover
MODEL: PREMIUM COVER 1
Hook
Swivelling anchor
Hook for cord