Herunterladen Diese Seite drucken

PIMAX PX 1139 L Montageanleitung Seite 3

Werbung

FT 39
ENGLISH
ENGL ISH
THIS INSTALLATION INSTRUCTION IS FOR BOTH LEFT AND RIGHT SIDE.
A) Disassemble the metal door panel and remove the glass from position 4. Remove the window regulator. Save the screws for
later.
B) Fix the electric window regulator into positions 1, 2 and 3 with the three screws previously removed. (NOTE: in the photo the
protective film has been removed).
C) Fix the upper cable sleeving with the clip supplied (photo A). Move the clip of the original wiring onto the lower hole, so that it
does not interfere with the motor connector (photo B).
D) Remount the metal panel. Reconnect the opening and locking rods.
E) Mount the window regulator driver 4 into the glass hole.
F) Wire as per wiring diagram. Check that the window operates correctly and re-fit door trim.
ENGLISH
FRANÇAIS
FRANÇAIS
CETTE INSTRUCTION DE MONTAGE EST POUR LES DEUX COTES DROIT ET GAUCHE.
A) Deposer le panneau en metal. Demonter le leve-vitre. Conserver les vis qui seront reutilisees.
B) Fixer le leve-vitre aux points 1, 2 et 3 avec les trois vis d'origine. (ATTENTION: sur la photo la protection plastique a ete
enlevee).
C) Fixer la gaine superieure avec le collier fourni (photo A). Deplacer le faisceau electrique d'origine pour ne pas gener le connecteur
electrique du moteur (photo B).
D) Remonter le panneau. Connecter les commandes d'ouverture et de fermeture de la porte.
E) Inserer le leve-vitre dans le trou de la vitre n° 4.
F) Effectuer les liaisons electriques. Controler le bon fonctionnement du leve-vitre electrique avant de remonter le panneau de la
portiere.
FRANÇAIS
DEUTSCH
DEUTSCH
DIESE MONTAGE-ANLEITUNG IST FÜR DIE BEIDE LINKE UND RECHTE SEITE.
A) Demontieren Sie die Türverkleidung und lösen Sie das Glas im Punkt 4 heraus. Demontieren Sie den Fensterhebermechanismus.
Heben Sie die Schrauben für später auf.
B) Befestigen Sie den Fensterheber an den Punkten 1, 2 und 3 mit den drei zuvor demontierten Schrauben. (ACHTUNG: in der
Abbildung ist die Schutzfolie abgenommen).
C) Befestigen Sie die obere Kabelleitung mit den mitgelieferten Kabelbindern (Abb. A). Versetzen Sie den Kabelbinder des Original-
Kabelsatzes in das untere Loch, damit Sie den Anschluss des Motors nicht stört (Abb. B).
D) Bauen Sie die Türverkleidung wieder ein. Installieren Sie den Tür-Öffner.
E) Montieren Sie den Mitnehmer an dem Punkt 4 im Glas-Loch.
F) Verlegen Sie die elektrische Verkabelung. Uberprüfen Sie die einwandfreie Funktion des elektrischen Fensterhebers.
DEUTSCH
ESPAÑOL
ESPAÑOL
ESTA INSTRUCCION DE MONTAJE ES PARA LOS DOS LADOS IZQUIERDO Y DERECHO.
A) Desmontar el panel metálico y sacar el cristal del punto n° 4. Desmontar el elevalunas. Conservar los tornillos para usarlos
después.
B) Fijar el elevalunas en los puntos 1, 2 y 3 con los tornillos anteriores. (ATENCION: en la foto, por comodidad, no parece el plástico
de protección).
C) Sujetar la guia superior con la brida adjunta (foto A). Hay que sacar la brida del cable original de su sitio para que no toque con
el motor del elevalunas (foto B).
D) Volver a montar el panel metálico.
E) Sujetar el cristal con la grapa en el punto n° 4.
F) Conectar los cables de alimentación, y comprobar el funcionamiento antes de volver a tapizar la puerta.
ESPAÑOL
ITAL IANO
ITALIANO
ITAL IANO
LA PRESENTE ISTRUZIONE VALE SIA PER IL LATO SINISTRO CHE PER IL LATO DESTRO.
A) Togliere il pannello di lamiera e sganciare il vetro nel punto n° 4. Smontare l'alzacristalli. Conservare le viti che verranno
riutilizzate.
B) Fissare l'alzacristalli nei punti 1, 2 e 3 mediante le tre viti precedentemente smontate. (ATTENZIONE: nella foto per praticità è
stata tolta la pellicola protettiva trasparente).
C) Fissare la guaina superiore con la fascetta in dotazione (foto A). Spostare l'aggancio dei cavi originali nel foro inferiore per non
interferire con il connettore motore (foto B).
D) Rimontare il pannello di lamiera. Collegare i comandi di apertura-porta e di blocco.
E) Agganciare il trascinatore dell'alzacristalli n° 4 nel foro del vetro.
F) Eseguire i collegamenti elettrici. Controllare il funzionamento dei cristalli prima di rimontare il pannello portiera.
18- 01- 2012

Werbung

loading

Diese Anleitung auch für:

Px 1139 r