Ada ZHT 100-70 Gebrauchsanweisung Seite 8

Technical Specifications
Humidity
Temperature
Temperature at depth
Wet bulb temperature
Refresh data
Operating the ZHT 100-70
Press the key (4) to switch the unit on/off.
HOLD key (3):
Press the key (3) in the measuring mode. The HOLD symbol appears on the display to indicate that the last
data on the display is locked. Press button (3) again to reset the data.
MAX/MIN button (5):
Press the button (5) in the measuring mode. The MAX symbol appears on the display. The maximum value
is shown on the display. Press the key (5) again. The MIN symbol appears on the display. The minimum
value is shown on the display.
Press and hold the button (5) to exit the maximum/minimum measuring mode.
MODE button (6):
Switch on the unit. Press the button (6). The display shows the measuring modes: Temperature, Dew point
temperature, Wet bulb temperature.
Switch the unit off. Press and hold the HOLD button (3). Then switch the unit on by pressing the button (4).
Select the temperature unit (°C/°F). By default, the unit is measured in °C.
Switch the unit off. Press and hold the MAX/MIN button (5). Then switch the unit on by pressing the button
(4). The icon
icon disappears from the display. The automatic switch-off function does not work. If the function (icon) is
deactivated, the unit is switched off by pressing the key (4)
Important: The icon
automatically after 15 minutes of inactivity.
Resolution
Accuracy of measurement
Measuring range
Resolution
Accuracy of measurement
Measuring range
Resolution
Accuracy of measurement
Measuring range
Resolution
Accuracy of measurement
0.5 s
that appears on the display informs you that the machine switches off
0.1°C
±3% (20 to 80%)
±4.5% (0 to 20% and 80 to 100%)
-20°C~70°C / -4°F to 158°F
0.1°C
±1.0ºС/±1.8ºF
-20°C~70°C / C6-4°F to 158°F
0.1°C
±1.5ºС/±2.7ºF
-20°C~70°C / -4°F to 158°F
0.1°C
±1.5ºС/±2.7ºF
.