Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The installation of the gooseneck microphone
Before the installation, please remove the black foam windshield to get the
exact position of the microphone exit.
The SM-NR-1 has been designed symmetrically, therefore it does'nt matter
which side of the two exits points to the back. Nevertheless, it is important
that the exist pointing to the back is running parallel to the mouth.
IMPORTANT!
A close talking microphone can only work properly when it is installed
centrically and close to the mouth and the back microphone exit is running
parallel to the mouth.
The mounting clamp is designed that the gooseneck microphone can be
installed in various helmet types:
Installation into helmets with cheek padding
Using the assembly clamp, the gooseneck microphone SM-NR-1 can be
installed either on the right or left side on top of the cheek padding.
Just choose the side you prefer.
Lead the connecting cable of the
microphone through the assembly
clamp.
Put the assembly clamp onto the
bigger part of the gooseneck
microphone. Now lead the connec-
ting cable to a space where you can
easily connect the helmet connection
cable.
Depending on the helmet used there
are various possibilities to install the
assembly clamp. If the padding is
permanently attached you can just
press the thorns between the outer
lining and the styrofoam. To get additional footing you can bend up the barbed
hook variantly to both sides or you can affix the even side at the bottom.
6
Werbung
