Arzum AR 3079 Gebrauchsanweisung Seite 14

USING YOUR TEA MAKER
• When you take the teapot to fill tea pull and take off its base from the
settled surface. Thus, the drops that accumulate on the base will be
poured in the water heater.
• Wash inside your Arzum Tea Maker by means of putting water in it
before the first use. Boil it for two or three times in the water heater and
change the water every time. Ensure that the water is at the maximum
level when you perform this process.
Discharge the hot water before every boiling
and wash inside your appliance with cold
water.
• Fill in your water heater water always
between the levels min (0.5 lt) or max (1,8 lt).
If you attempt boiling the water under the
minimum level, it will cause your appliance to
be shut off earlier
and if you attempt
the water above
the maximum level,
it will cause water
to overflow.
• Open the teapot
lid and remove the
tea filter and add
sufficient amount of tea in the filter and add some cold water and then
replace it on the teapot.
• Open by taking the main switch to "I" and the boiling switch to position.
The red pilot light will be on and the water will start heating.
• Depending on the amount of water added, the water will start boiling
within 3-8 minutes and the boiling switch will pass automatically to the
closed position and it will decrease the heating power to keep the water
boiling at the minimum level and to provide the energy saving. Meanwhile,
the red pilot light will go out and the green pilot light will be on.
14 ARZUM