Behringer XENYX UFX1604 Schnellstartanleitung Seite 16

30 XENYX UFX1604
Recording to USB drive in STAND-ALONE mode
Step 7: Recording
(EN)
to USB drive in
STAND-ALONE
mode
*press PLAY to confirm / any other button to abort
Although USB sticks and 2.5" USB-powered external drives could work, the use of powered hard drives for direct recording with the internal USB
recorder is recommended.
Downloaded from ManualsNet.com search engine
Transport Control Feature Chart
Show Remaining Time
Press TIME REMAIN short
Push and hold TIME REMAIN button until the
Show Sampling Rate
sample rate is displayed
Select Sampling Rate 44.1 kHz
Push and hold TIME REMAIN until the
sample rate appears and then press
holding TIME REMAIN
Select Sampling Rate 48 kHz Push TIME REMAIN until the sample rate
appears and then press
TIME REMAIN
Press PLAY (to start) > press PLAY (to pause)
Toggle PLAY<>PAUSE
> press PLAY (to continue) > etc.
Toggle Recording Mode (e.g. "001") <>
Playlist Mode (e.g. "P01")
Push TIME REMAIN +
Toggle Single Playback ("Pxx") <>
Push PLAY for two seconds
Continuous ("cxx") Playlist [only in Playlist Mode]
FAT-formatting the USB drive*
Press together STOP +
Delete current song (in Recording Mode)*
Press together PLAY +
Error Codes:
Dropout while recording. A summary of the total
DrP number of dropouts will be displayed after recording
(e.g. d03).
File system error. Incompatible fi le system on the drive.
FSE
Drive must be formatted by the UFX.
Recorder switches off if a drive has been specifi ed as
oFF
SLO (too slow).
The connected USB drive has been specifi ed as
SLO
too slow. No recording will be possible.
31 Quick Start Guide
Using the MIDI CONTROL Features
Step 8: Using the
(EN)
MIDI CONTROL
Features
while still
while still holding
for two seconds
for two seconds
for two seconds
The TRANSPORT CONTROL section on the UFX1604
can operate as a MIDI controller in one of two modes:
STANDARD MIDI MODE or MACKIE CONTROL MODE.
The Mixer must be turned off .
To select MACKIE CONTROL MODE,
hold , turn the power on and then
release when "MAC" shows up in
the display. To select STANDARD MIDI MODE,
Hold , turn the power on, then release
when "STD" shows up in the display.
For STANDARD MIDI MODE, map the
transport controls in your recording
software to the TRANSPORT CONTROL
buttons on the UFX1604. In MACKIE CONTROL MODE,
set your recording software to follow the
appropriate protocol.
For further information, see the full manual at
behringer.com.