Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
22. Have your tool repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorized service centre is recommended.
This electric tool is in accordance with the relevant safety requirements. Repairs shou ld only be
carried out by qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
23. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
SPECIAL WARNINGS WHEN USING THE PRODUCT
1. Become familiar with the controls and the proper use of the product.
2. The use of this product by children, without adult supervision, is forbidden.
3. Only well-instructed adults should operate the product.
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved.
- children shall not play with the appliance.
- cleaning and user maintenance shall not be made by children without supervision from an adult
.
4. Use only accessories adapted for the head of the soldering gun or soldering iron.
5. Do not use tool if damaged, eccentric or vibrating.
6. Never seize the heating tip or upper housing during operation
7. Always stop the tool and allow it to cool down before putting it down (note: Ensure that tip is no
longer hot when you put down the tool)
8. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect plug
from its main power source. Do not touch the cable or extension cord before unplugging from main
power.
9. Before use, always inspect soldering gun.
Werbung
