Worx Nitro WG185E Originalbetriebsanleitung Seite 12

SUGGESTED BATTERIES AND
CHARGERS
Category
20 V Battery
20 V Charger
We recommend that you purchase your accessories
listed in the above list from the same store that
sold you the lawn trimmer. Refer to the accessory
packaging for further details. Store personnel can
assist you and offer advice.
NOISE INFORMATION
A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection.
12
VIBRATION INFORMATION
Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the
tool is used dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed
Cordless Grass Trimmer
Model Capacity
WA3014 4.0 Ah
WA3644 4.0 Ah
WA3883 4.0 A
L = 78.4 dB(A)
pA
3 dB(A)
L = 92.5 dB(A)
wA
3 dB(A)
a < 2.5 m/s
h
K = 1.5 m/s²
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4.ASSEMBLY & OPERATION
Action
Assembly
Assembling the Auxiliary Handle
Removing the tube plug
NOTE: Before assembling the
pole, Please remove the tube plug
protector on the machine first.
Assembling the pole
Assembling the Safety Guard
2
Insert the metal bracket into the
slot on the safety guard, then
secure the guard in place using the
screw and hex key.
Installing and Removing the
Battery Pack
NOTE:
• This machine will only run
when 2 batteries are installed.
It is recommended to use the
same two batteries and charge
the two batteries at the same
time.
• When two batteries are used
with different amp hours or
charge level, the machine will
run to the lowest common
denominator.
• It is recommended that using
4.0Ah or above battery pack for
better performance and longer
run time.
Figure
See Fig.
A1,A2,A3
See Fig. B1
See Fig. B2
See Fig. C
See Fig. D1, D2
EN