JVD SB3618 Gebrauchsanweisung Seite 10

•
The set range is: hour is 1~12 or 0~23, minute is 00~59; the snooze interval is 1-60 minutes and the
default is 5 minutes; the default alarm is 1-7 daily alarm.
•
In the setting mode, it will escape the setting mode by press ALM key /without any key for 10s , and then
it will return to the time mode.
•
When the alarm reaches the point, it will automatically return to the alarm mode, with a "didididi" alarm
sound, from slow to faster, and the alarm sign flashes at the same time, you can press any key to stop
the alrrm. Or there is no key operation and the alarm stops for 1 minute, but the alarm sign will not
disappear.
•
When the alarm rings, press the SNOOZE key to stop ringings and turn on one snooze, the alarm sign
will flash; press other keys (except SNOOZE key) can stop ringing but no snooze.
•
During the snooze interval, press other keys to turn off the snooze; pressing the SNOOZE key does not
affect the snooze.
•
When the alarm stops ringing, the alarm state is displayed, and it returns to the time state after 10s.
•
In the alarm setting mode,it will stop ringing.
J. Temperature mode
•
After connecting the power, the clock will automatically detect the temperature, press MODE key to
enter the the temperature mode. The normal measurement range is -10℃~50℃(14℉~122℉).
•
When the temperature below -10℃,the screen displays -10℃;When the temperature above 50℃,the
screen displays 50℃; When it has no resistance, the screen displays -10℃.
•
The clock will detect the temperature every 10s, in the temperature mode press DOWN key to
switch ℃/℉.
•
In the temperature mode, press and hold the MODE key until there is a BI beep, and switch to LED to
display the time, date and temperature in turn, the time is displayed for 10s, and the date and
temperature are displayed for 3s; then press and hold the MODE key again until there is a BI beep and
display the normal time.
K. Night mode
•
In the normal time/date/temperature mode, press SNOOZE key to set brightness,
High --middle--Low--Off three modes.
•
In the time mode, press MODE key 3 times to enter the night setting mode, press UP or DOWN to turn
on (ON)/off (OFF) night mode (the default is off (OFF) night mode).
•
When the night mode turns on, during 18:00-5:59 the screen is in low light automatically.
•
In the night mode, if the brightness is not adjusted, after exiting it will display the brightness you set
before.
•
When the night mode is ON, press and hold the MODE key for about 2s to enter the night mode time
setting.
•
The setting sequence is: start hour → start minute → end hour → end minute.
L. Projection function
•
The projection adopts LCD display, and only the time is displayed at any time without turning off the
screen. Even if the main screen LED goes off, the LCD projection does not need to be turned off. Even if
the main LED screen is off, pressing LIGHT key can also turn on the projection to check the time.
•
No matter what mode the LED main screen displays, the projection only displays the time.
•
When setting the time mode, the LCD can display synchronously with the main screen LED, but when
setting other modes, the LCD screen only stays in the time mode.
•
Press LIGHT key at any time to turn on the projection （two brightness:high light and low） to check
the time.
10