Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
1
Lay the seat board 昀氀at on the
昀氀oor so that the seating area
faces the 昀氀oor.
4
Identify frame B. (When stood
up frame B has a cut-out on
the top of the tube and the
underside of the tube is 昀氀at.
7
Take one of the legs and put
it onto one of the frame ends.
Push down the securing pin
and twist the leg to the side
to allow you to slide the leg
up or down to the desired
height.
HEIGHT ADJUSTMENT
For adjusting the height, please look at ASSEMBLY point 7-9.
2
Identify frame A. (When stood
up frame A has a 昀氀at top and
a cut-out on the underside of
the tube).
5
Attach frame B to the seat
board, using 2 x screws and
2 x washers.
8
If you found the correct
height, rotate the leg back to
allow the securing pin to pop
out of the hole and 昀椀x the
height at the correct setting.
Make sure the securing pin
poped out completely.
3
Attach frame A to the seat
board, using 2 x screws and
2 x washers.
6
Secure both frames to the
seat board using 1 x screw
and 1 x washer.
9
Repeat steps 7 and 8 for each
leg, ensuring that all four legs
are set to the same height
setting.
EN
Werbung
