Replace The Lamp - Pyramis Fsn 195 Inox Gebrauchsanleitung

Daily Use

Replace the lamp

The internal light is a LED type. To replace the lamp, please contact qualified technician.
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician
of competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
Appliance freezes or
cools too much
The food is not frozen
enough
Heavy build up of
frost on the door seal
Unusual noises
Water on the floor
Side panels are hot
If the malfunction shows again, contact the Service Center. These data are necessary to
help you quickly and correctly.
Possible cause
Temperature regulation knob is set at coldest
Mains plug is not plugged in or is loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or the appliance
runs at coldest
Temperature is not properly adjusted
Door was open for an extended period
A large quantity of warm food was placed in
the appliance within the last 24 hours
The appliance is near a heat source
Door seal is not air tight
Appliance is not level
The appliance is touching the wall or other
objects
A component, e.g. a pipe, on the rear of the
appliance is touching another part of the appli-
ance or the wall
Water drain hole is blocked
It's normal. Heat exchange parts are in the sides
Solution
Set the knob at other switch on the
appliance
Insert mains plug
Check fuse, replace if necessary
Mains malfunctions are to be correct-
ed by an electrician
Turn the temperature regulator to a
warmer setting temporarily
Please look in the initial Temperature
Setting section
Open the door only as long as
necessary
Turn the temperature regulation to a
colder setting temporarily
Please look in the installation location
section
Carefully warm the leaking sections of
the door seal with a hair dryer (on a
cool setting). At the same time shape
the warmed door seal by hand such
that it sits correctly
Re-adjust the feet
Move the appliance slightly
If necessary, carefully bend the com-
ponent out of the way
See the Cleaning and Care section
Take gloves to touch sides if needed
21