Herunterladen Diese Seite drucken

HQ Power ANTM6 Kurzanleitung

Antennenverstärker mit 4 ausgängen

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

ANTM6 – ANTENNA AMPLIFIER WITH 4 OUTPUTS
1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the ANTM6! Please read the manual carefully before bringing this device into service.
This antenna amplifier is designed to improve the picture and sound quality of TV and FM radio signals and distribute
these to multiple locations around your home. The ANTM6 can also be used to distribute a VCR, digital television
and FREEVIEW signal to four televisions around the home. For added safety, your ANTM6 has a built-in short-circuit
protection on each individual output. Should a short-circuit be detected, the amplifier will only shut down the output
with the short-circuit while all other outputs will continue to function as normal. Your ANTM6 is easy to install and
fully automatic in operation.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• A qualified technician should install and service this device.
• Damage caused by disregarding certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for the ensuing defects or problems.
• Do not switch the device on immediately if it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage from sharp edges. Ask an authorised dealer to replace
the cord if necessary.
• Always disconnect the device from the mains when it is not in use or when you wish to clean it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
• Note that damage caused by user modifications to the device is not covered by the warranty. Keep the device
away from children and unauthorised users.
3. General Guidelines
• This device should only be operated with an alternating current of max. 230VAC / 50Hz and is designed for indoor
use only.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust.
• Do not use the device if the ambient temperature exceeds 45°C.
• Familiarise yourself with the functions of the device before actually using it. Do not permit operation by unqualified
people. Any damage that may occur will probably be due to unprofessional use of the device.
ANTM6
1
VELLEMAN

Werbung

loading

Inhaltszusammenfassung für HQ Power ANTM6

  • Seite 1 Should a short-circuit be detected, the amplifier will only shut down the output with the short-circuit while all other outputs will continue to function as normal. Your ANTM6 is easy to install and fully automatic in operation.
  • Seite 2 UHF 470 – 863MHz VHF 47 – 230MHz Gain 12dB per split Noise < 3.5dB Isolation Loss 23dB Weight 0.518kg Dimensions 177 x 85 x 46mm The information in this manual is subject to change without prior notice. ANTM6 VELLEMAN...
  • Seite 3 Houd dit toestel uit de buurt van kinderen en onbevoegden. 3. Algemene richtlijnen • U mag dit toestel enkel gebruiken met een AC stroom van max. 230VAC / 50Hz en de ANTM6 is enkel geschikt voor gebruik binnenshuis. • Schud het toestel niet dooreen. Vermijd brute kracht tijdens de installatie en de bediening van dit toestel.
  • Seite 4 Digitaal signaal is te zwak of te sterk. Installeer een breedbandantenne zodat het signaal wordt verbeterd. Installeer een signaalverzwakker tussen de antenne en de DTT- ontvanger zodat het signaal wordt verzwakt. Problemen met satelliettelevisie Losse aansluiting. Zorg dat alle kabels en connectoren correct zijn aangesloten. ANTM6 VELLEMAN...
  • Seite 5 Cet amplificateur d’antenne a été conçu pour améliorer la qualité de l’image et du son des signaux de votre téléviseur ou de votre radio FM. En plus, l’ANTM6 distribue ce signal vers tous les coins de votre maison. Cet appareil peut également être utilise pour distribuer un signal provenant de votre magnétoscope ou télévision numérique vers quatre téléviseurs dans la maison.
  • Seite 6 • Il est interdit de modifier l'appareil pour des raisons de sécurité. • Employez la ANTM6 uniquement pour les applications décrites dans ce manuel afin d'éviter les courts-circuits, les brûlures, les électrochocs, etc. Un usage interdit peut occasionner des dommages et annule d'office la garantie.
  • Seite 7 Este amplificador de antena ha sido diseñado para mejorar la calidad de la imagen y del sonido de las señales del televisor o de la radio FM. Además, el ANTM6 envía esta señal a todos los rincones de su casa. También, es posible utilizar este aparato para enviar una señal que viene del VCR o de la televisión digital a cuatro televisores en...
  • Seite 8 • Por razones de seguridad, las modificaciones no autorizadas del aparato están prohibidas. • Utilice sólo el ANTM6 para aplicaciones descritas en este manual a fin de evitar p.ej. cortocircuitos, quemaduras, descargas eléctricas, etc. Un uso desautorizado puede causar daños y anula la garantía completamente.
  • Seite 9 Falls Zweifel bestehen, wenden Sie sich für Entsorgungsrichtlinien an Ihre örtliche Behörde. Danke für den Kauf des ANTM6! Bitte lesen Sie diese Bedienungsanleitung vor Inbetriebnahme sorgfältig durch. Dieser Antennenverstärker wurde entworfen zum Verbessern der Bild- und Tonqualität von Fernseh- und FM- Funksignalen und zur Übertragung dieser Signale an verschiedene Stellen in Ihrem Haus.
  • Seite 10 Zu starkes Signal oder einen starken Verwenden Sie einen Signaldämpfer lokalen Sender wie CB, Amateur- um die Verstärkung Ihrer Antenne zu oder Taxifunk. reduzieren. Richten Sie die Antenne auf einen anderen Sender um ein besser geeignetes Signal zu bekommen. ANTM6 VELLEMAN...
  • Seite 11 Abmessungen 177 x 85 x 46mm Alle Änderungen vorbehalten. Installation – Installatie – Installation – Instalación – Installation Method 1 Method 2 Methode 1 Methode 2 Méthode 1 Méthode 2 Método 1 Método 2 Methode 1 Methode 2 ANTM6 VELLEMAN...