Buffalo CU558 Bedienungsanleitung Seite 6

EN
Auto shut-off function
The appliance will shut off automatically when left idle for about 4 hours.
Overheat protection function
If the pan becomes too hot the appliance will switch off and a buzzer will sound. Should this happen,
allow the appliance to cool before restarting.
Cleaning, Care & Maintenance
• Turn the appliance off and disconnect from the power supply. Allow the appliance to cool before
cleaning and maintenance.
• Use warm, soapy water and a damp cloth to clean the appliance.
• DO NOT use abrasive cleaners or pads.
• Dry thoroughly after cleaning.
• For optimal product performance, it is recommended to regularly apply some vegetable oil to the
cooking surface.
Cleaning the air filters
• There are 2 removable air filters on the bottom of the appliance. Pull them out and clean with a
vacuum cleaner. Put back afterwards.
• Replace with new filters if necessary.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault
The unit is not working
Indicator light keeps
flashing Red for 1
second then going out
Indicator light keeps
flashing Red for 2
seconds then going out
Indicator light keeps
flashing Red for 3
seconds then going out
Indicator light keeps
flashing Red for 4
seconds then going out
6
CU558_ML_A5_v1_20230918.indb 6 CU558_ML_A5_v1_20230918.indb 6
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Unsuitable cookware
Unsuitable cookware / no
cookware
Appliance has overheated
Temperature sensor is
damaged
Input voltage is too high/
low
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Replace with suitable cookware
Replace with suitable cookware
Check ventilation slots for blockage. Allow to
cool before attempting to use again.
Replace temperature sensor
Make sure the mains power supply is suitable
for the appliance.
2023/9/18 11:39 2023/9/18 11:39